auszookers.com
https://auszookers.com/forum/

LWB well lining
https://auszookers.com/forum/viewtopic.php?f=5&t=12349		 Page 1 of 1
Author:  Chopz [ Mon May 31, 2010 2:40 pm ]
Post subject:  LWB well lining
I just picked up a 96 LWB stockman (keep an eye out for it in the rigs section) and I was wanting to sand down the well in the back and paint it or spray it with something thats a bit more heavy duty, similar I spose to the body or chassis tar or sealant that is used on wheel arches, etc.

Something along those lines, has anyone done or know of anything like a spray on lining at all....or would that stoneguard stuff just be sufficent??
Author:  eldo [ Mon May 31, 2010 8:39 pm ]
Post subject:  Re: LWB well lining
Don't us tar based stuff, you wantwater based stone guard
Author:  Crunched [ Mon May 31, 2010 9:04 pm ]
Post subject:  Re: LWB well lining
Chopz wrote:
I just picked up a 96 LWB stockman (keep an eye out for it in the rigs section) and I was wanting to sand down the well in the back and paint it or spray it with something thats a bit more heavy duty, similar I spose to the body or chassis tar or sealant that is used on wheel arches, etc.

Something along those lines, has anyone done or know of anything like a spray on lining at all....or would that stoneguard stuff just be sufficent??

8O

Stekky will love this thread.

Do a search for 'buttercup'. Although searching buttercup will probably result in about a million threads now that I think of it.

Quick answer - don't use tar. Or if you do, don't sell it to a post-whoring man from Brisbane.
Author:  2stroker [ Tue Jun 01, 2010 1:40 am ]
Post subject:  Re: LWB well lining
I have been using water based stone guard, you get it in a 1 litre container and use a special application gun/nossle that srews into the top, you can paint whatever colour over it. I have tried the spray cans but they don't give as good a finish.

Supercheap Auto now have a ute tray paint kit, it is a specific 2 part paint system for ute trays, it is apparently very good, hard wearing and stays on awesome. It also has a textured non slip finish and come in a few colours, I think its about $140.

For a roughy I have also used industrial hammer finish paint which again is pretty hard wearing.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/