| auszookers.com https://auszookers.com/forum/ |
|
| Sierra Seats https://auszookers.com/forum/viewtopic.php?f=5&t=12391 |
Page 1 of 1 |
| Author: | Zook_Fan [ Wed Jun 02, 2010 7:53 am ] |
| Post subject: | Sierra Seats |
There is a large problem with the availability of decent sierra seats, particularly the driver side bases. So I was wondering if anyone has struck gold and found another base that will bolt to the top half of a sierra seat and relatively bolt to the sierra rails without massive modifications? |
|
| Author: | Gwagensteve [ Wed Jun 02, 2010 8:01 am ] |
| Post subject: | Re: Sierra Seats |
Some autotechnica are very close to a bolt in. Early MX-5 and CR-X are also very close to a bolt in, however, they are light, small seats and wear quickly with fat aussie bums on them too. I'm not aware of anything that's a 100% bolt in. Normally the best you could hope for is two of the four holes to line up. Seats are pretty important though - make sure you do it right. Steve. |
|
| Author: | Zook_Fan [ Wed Jun 02, 2010 8:07 am ] |
| Post subject: | Re: Sierra Seats |
its only for a roadworthy. its going to get my reclining bucket seats later when i upgrade to fixed buckets out of my shortie, i know that seats are important and extremely so offroad but this is a short term fix. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|