lump_a_charcoal wrote:
Bring it up here, Timaay can use my welder to do it.
| auszookers.com https://auszookers.com/forum/ |
|
| [ACT] - looking for a welder/fab shop https://auszookers.com/forum/viewtopic.php?f=5&t=12459 |
Page 1 of 1 |
| Author: | Red_October [ Fri Jun 04, 2010 10:50 am ] |
| Post subject: | [ACT] - looking for a welder/fab shop |
I'm looking for a place/someone in ACT who could weld a winch perch/bracing to my existing custom bar. I imagine it's not too big a job and shouldn't take too long but i'd like it done right. Any recommendations? I need to get this sorted in the next week or two. Cheers Jimmy |
|
| Author: | lump_a_charcoal [ Fri Jun 04, 2010 12:26 pm ] |
| Post subject: | Re: [ACT] - looking for a welder/fab shop |
Bring it up here, Timaay can use my welder to do it. |
|
| Author: | chef [ Fri Jun 04, 2010 9:44 pm ] |
| Post subject: | Re: [ACT] - looking for a welder/fab shop |
call me ill give u eric number he dose all the work for our club |
|
| Author: | BlueSuzy [ Fri Jun 04, 2010 11:09 pm ] |
| Post subject: | Re: [ACT] - looking for a welder/fab shop |
lump_a_charcoal wrote: Bring it up here, Timaay can use my welder to do it.
|
|
| Author: | Red_October [ Fri Jun 11, 2010 7:20 am ] |
| Post subject: | Re: [ACT] - looking for a welder/fab shop |
Cheers for the contact chef 
I know have a 9000lb winch mounted 
|
|
| Author: | zooker [ Fri Jun 11, 2010 7:32 am ] |
| Post subject: | Re: [ACT] - looking for a welder/fab shop |
How much he charge you? |
|
| Author: | Red_October [ Fri Jun 11, 2010 7:34 am ] |
| Post subject: | Re: [ACT] - looking for a welder/fab shop |
Lots  But i'd still recommend him as his work is top notch. Just get a quote first so you don't have a heart attack.
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|