| auszookers.com https://auszookers.com/forum/ |
|
| rocker cover gesket https://auszookers.com/forum/viewtopic.php?f=5&t=12505 |
Page 1 of 1 |
| Author: | Shansh [ Sun Jun 06, 2010 3:25 am ] |
| Post subject: | rocker cover gesket |
anyone else had any issues with a new rocker cover gasket not fitting on a g13a? the tabs and curves line up but the gasket is then too long at one end then short at the other & its not from the curve in the cover for the cam housing either, the gasket just seems "offset" if that makes any sense |
|
| Author: | steak_knife [ Sun Jun 06, 2010 3:32 am ] |
| Post subject: | Re: rocker cover gesket |
Have you tried tuning the gasket around? |
|
| Author: | MacDaddy [ Sun Jun 06, 2010 4:08 am ] |
| Post subject: | Re: rocker cover gesket |
Shansh wrote: anyone else had any issues with a new rocker cover gasket not fitting on a g13a? the tabs and curves line up but the gasket is then too long at one end then short at the other & its not from the curve in the cover for the cam housing either, the gasket just seems "offset" if that makes any sense
Did you try flipping it over and trying it the other way round ? It may just be a bad cutout of the gasket, take it back and get another one !  
|
|
| Author: | 31zook [ Sun Jun 06, 2010 4:40 am ] |
| Post subject: | Re: rocker cover gesket |
repco all ways give me the wrong one, just gaskit goo it. |
|
| Author: | Thanh [ Sun Jun 06, 2010 4:42 am ] |
| Post subject: | Re: rocker cover gesket |
there is 4 ways you can fit it. try all of them. i just did my rc gasket on my g13a and it fitted ok. took abit of mucking around thats all |
|
| Author: | Shansh [ Sun Jun 06, 2010 8:00 am ] |
| Post subject: | Re: rocker cover gesket |
all good fucked around with it for a while, thanks guys |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|