I rebuilt my standard 1.3 Tcase yesterday, did it properly with all new bearings and seals, i removed the denten ball while it was out and put my twin stick set in. I used a press and a bearing puller, to get everything off (so i didn't heat anything) and now it has a bit of a whine and a funny noise. Im guessing the whine is i've moved the gears just a tiny bit and there wearing into each other again, but the noise is more like putting a base ball card in the spokes of your bike. It only happens when im cruising along with not much load on it. If i give it a boot full it goes away, and in 5th i can't get it to go away, was thinking a can't put enough load on it with the motor to stop it in higher gears.
could the twin sticks have anything to do with it? and there isn't all that much play in it when you grab the input and give it a twist with your hands....
i was going to buy some thicker oil and try to see if it's going to deaden the noise that way till they wearing.
am i sitting on a time bomb.
cheers
