[lump_a_charcoal]

Guys,

I did a few searches but coldn't find any tips...

I am replacing my front left guard, and I am wondering if there are any tips for getting the phillips head bolts undone that are all over the car?

Impact driver I reckon is the go for the door hinges, but what about the smaller buggers? Heat? Drill/eze-out?

Also, is it hard to get the glue undone on the front clip?

[steve]

you mean the star head ones that are at the front of the guards that connect them to the from grill section? yeah they're a pain. I just cut the heads off then drilled em out later and used another straight through bolt to connect em again