| auszookers.com https://auszookers.com/forum/ |
|
| Need help! Indentifiying G13BA engine part? https://auszookers.com/forum/viewtopic.php?f=5&t=12979 |
Page 1 of 1 |
| Author: | w8stedYouth [ Wed Jun 23, 2010 1:22 am ] |
| Post subject: | Need help! Indentifiying G13BA engine part? |
What is the part called- It connects the dizzy cap( and points) to the engine through a manifold of some type? The reason I ask is that my 93 sierra is running bad after not being started for a year and now the engine oil is leaking from the bottom bolt of this part. If not its my head and I really hope not! Thanks in advance for any help!!! |
|
| Author: | 2stroker [ Wed Jun 23, 2010 1:54 am ] |
| Post subject: | Re: Need help! Indentifiying G13BA engine part? |
That is a really, really, really bad description but I think you mean the distributor housing. It is a 1993 sierra so I am assuming it is a 1300, if so the housing is held on by 3 bolts and has an "O" ring seal. If it is a 1 litre (maruti) then the housing is held on by 3 bolts and has a gasket seal. This will not account for your engine running bad but can account for oil leaks. |
|
| Author: | Hybrid [ Wed Jun 23, 2010 2:22 am ] |
| Post subject: | Re: Need help! Indentifiying G13BA engine part? |
x2 for the distributor housing o-ring. Mine is leaking right now. As did the one on my old engine. |
|
| Author: | w8stedYouth [ Wed Jun 23, 2010 2:27 am ] |
| Post subject: | Re: Need help! Indentifiying G13BA engine part? |
I pulled mine apart and put back on with gasket glue, but now it wont kick over? What tha? |
|
| Author: | Ben_Sierra [ Wed Jun 23, 2010 2:36 am ] |
| Post subject: | Re: Need help! Indentifiying G13BA engine part? |
Did ya put it back with the rotor button pointing the right way? Or just stick it back in... |
|
| Author: | w8stedYouth [ Wed Jun 23, 2010 2:54 am ] |
| Post subject: | Re: Need help! Indentifiying G13BA engine part? |
Just put it back. Doesnt sound good. What do I do? |
|
| Author: | Ben_Sierra [ Wed Jun 23, 2010 3:02 am ] |
| Post subject: | Re: Need help! Indentifiying G13BA engine part? |
Take the dizzy out, turn the engine by hand to Top Dead Centre on number 1, put the dizzy back in so the rotor faces the number one lead. |
|
| Author: | w8stedYouth [ Wed Jun 23, 2010 5:35 am ] |
| Post subject: | Re: Need help! Indentifiying G13BA engine part? |
Thanks guys just found out what TDC is and all makes sense now |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|