| auszookers.com https://auszookers.com/forum/ |
|
| LJ50 head https://auszookers.com/forum/viewtopic.php?f=5&t=13020 |
Page 1 of 1 |
| Author: | Wrinkledbits [ Thu Jun 24, 2010 7:14 am ] |
| Post subject: | LJ50 head |
does anyone know if the head on the LJ50 where mill finish or polished |
|
| Author: | 3cyl [ Thu Jun 24, 2010 9:43 am ] |
| Post subject: | Re: LJ50 head |
You mean the gasket face? Straight from the mill to the gasket. |
|
| Author: | Wrinkledbits [ Thu Jun 24, 2010 10:44 am ] |
| Post subject: | Re: LJ50 head |
no, the up side of the head, the part you see, i would like to have looking as original as i can. |
|
| Author: | 303zuke [ Thu Jun 24, 2010 1:41 pm ] |
| Post subject: | Re: LJ50 head |
Wrinkledbits wrote: no, the up side of the head, the part you see, i would like to have looking as original as i can.
Finished as cast. |
|
| Author: | Wrinkledbits [ Fri Jun 25, 2010 7:24 pm ] |
| Post subject: | Re: LJ50 head |
thanks for that, i had seen some polished, but wasn't sure if that was standard. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|