These were of the shelf f100 15x8s
| auszookers.com https://auszookers.com/forum/ |
|
| F100 rims https://auszookers.com/forum/viewtopic.php?f=5&t=13225 |
Page 1 of 1 |
| Author: | bulldoggy [ Fri Jul 02, 2010 4:01 am ] |
| Post subject: | F100 rims |
What f100 rims are suitable for the zook to run 31s without scrubbing the leaf? Anyone got a backspacing measurement they are an 8" rim and free just not sure or the amount needed to keep them closish to the widetrack with a 25mm rubber flare attatched. Cheers. Its a 89 hardtop WT |
|
| Author: | ThirstyV6 [ Fri Jul 02, 2010 6:41 am ] |
| Post subject: | Re: F100 rims |
I ran ROH and Speedy 15x7 sold to me as F100 rims, with 235's and 2" lift neither rubbed or scrubbed and were just outside guards so 31's will need flares. |
|
| Author: | finlay113 [ Fri Jul 02, 2010 7:29 am ] |
| Post subject: | Re: F100 rims |
i ust to have 31 all terrains on 15x8 f100 rims on my WT. had to put 2 inch rubber flares on aswell to cover tyres. still only just covered them |
|
| Author: | Joe [ Fri Jul 02, 2010 7:32 am ] |
| Post subject: | Re: F100 rims |
These were of the shelf f100 15x8s
|
|
| Author: | zot_boy [ Sat Jul 03, 2010 8:03 am ] |
| Post subject: | Re: F100 rims |
i just tried to put 31's on today springs where not the problem but the front you need to get the hammer out also it tryed to rip my flares off im going to have to take them off and do some modding to make them higher or lengthen the bump stops has any one els had this problem they are 31x 10.5 |
|
| Author: | just_cruizin [ Sat Jul 03, 2010 11:35 pm ] |
| Post subject: | Re: F100 rims |
Back spacing is available in -12.5 or about -24. GO the -24's they are much better as far as scrub goes, especially with 10.5 tyres. Worry about the flares to cover them once they're on. |
|
| Author: | SuziBlu [ Sat Jul 03, 2010 11:43 pm ] |
| Post subject: | Re: F100 rims |
I put 8" f100 offset, cant remember, but it was the max that was available. Put 31x10.5 baja claws on, and they scrubbed the chassis bad, put 38mm spacers on, prob solved |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|