| auszookers.com https://auszookers.com/forum/ |
|
| Making a rear bar https://auszookers.com/forum/viewtopic.php?f=5&t=13250 |
Page 1 of 1 |
| Author: | pyrohamish [ Sat Jul 03, 2010 9:41 am ] |
| Post subject: | Making a rear bar |
Gonna make it out of ~2mm steel, with weld on brackets (~6mm) onto the tube (going to sleeve in some more tube, heavy wall and plug weld) between the chassis rails. Cut it with cnc plasma and fold it up 
Anyone know the diameter of the haymen-reese hitch pin? All being well, have some decent snatch points and a shweet bar 
|
|
| Author: | steak_knife [ Sat Jul 03, 2010 10:00 am ] |
| Post subject: | Re: Making a rear bar |
I think a tow hitch will bugger your ZU l |
|
| Author: | pyrohamish [ Sat Jul 03, 2010 10:12 am ] |
| Post subject: | Re: Making a rear bar |
wasnt planning on a tow hitch, just wanted to use the pin |
|
| Author: | Rusho [ Sat Jul 03, 2010 10:14 am ] |
| Post subject: | Re: Making a rear bar |
Looks good mate....well done
|
|
| Author: | Fatzook [ Sat Jul 03, 2010 10:33 am ] |
| Post subject: | Re: Making a rear bar |
use 3mm minimum. one hit on the corner and that thing will twist up instantly. |
|
| Author: | jdk81 [ Sat Jul 03, 2010 11:46 am ] |
| Post subject: | Re: Making a rear bar |
The hole for the hitch reciever pin is 16mm, the pin is slightly less than 16mm |
|
| Author: | Fatzook [ Sat Jul 03, 2010 11:53 am ] |
| Post subject: | Re: Making a rear bar |
where does your number plate go? Female hitch material is 65mm shs, 6mm wall. The hitch is 51 mm SHS or solid, but you need to be carefull to match the corner radius'. |
|
| Author: | pyrohamish [ Sat Jul 03, 2010 12:44 pm ] |
| Post subject: | Re: Making a rear bar |
I'm going to make a bracket up off the spare weel. |
|
| Author: | Fatzook [ Sat Jul 03, 2010 12:46 pm ] |
| Post subject: | Re: Making a rear bar |
pyrohamish wrote: I'm going to make a bracket up off the spare weel.
cool.
|
|
| Author: | 303zuke [ Sat Jul 03, 2010 12:49 pm ] |
| Post subject: | Re: Making a rear bar |
jdk81 wrote: The hole for the hitch reciever pin is 16mm, the pin is slightly less than 16mm
5/8" = 15.875mm |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|