| auszookers.com https://auszookers.com/forum/ |
|
| Box issue https://auszookers.com/forum/viewtopic.php?f=5&t=13310 |
Page 1 of 1 |
| Author: | jonno_racing [ Mon Jul 05, 2010 12:22 pm ] |
| Post subject: | Box issue |
Ok recently me and superduki rebuilt my gearbox, long and the short of is is.. we are using the coily gearset in a NT housing.. my housing was trashed. issues are.. the gearbox is nearly locked up.. its turnable but only just.. MASIVE strain on motor in nutral (drops about 500rpm at idel when u pull the clutch out) and the shifter rails, all of them are... well basicly seased.. we have got them to move a little bit with bruit force but yeah... any ideas guys? |
|
| Author: | Gwagensteve [ Mon Jul 05, 2010 12:30 pm ] |
| Post subject: | Re: Box issue |
Coil sierras had slightly different ratios for at least some gears. Did you measure both gearsets to ensure they were exactly the same size? Steve. |
|
| Author: | jonno_racing [ Mon Jul 05, 2010 12:35 pm ] |
| Post subject: | Re: Box issue |
2 be honest no. they appeard to be completley identical and went together very smoothly... we were thinking maby the box was a tad tight due to new bearings etc.. but this is stupid! |
|
| Author: | JrZook [ Mon Jul 05, 2010 1:06 pm ] |
| Post subject: | Re: Box issue |
jonno_racing wrote: 2 be honest no.
they appeard to be completley identical and went together very smoothly... we were thinking maby the box was a tad tight due to new bearings etc.. but this is stupid! Went together very smoothly?? Do u rotate the input shaft and check gear selection before you put it in your car? Pull it out again and check if all teh bearings are full seated. I had a tight box because of this. |
|
| Author: | jonno_racing [ Mon Jul 05, 2010 1:08 pm ] |
| Post subject: | Re: Box issue |
yeah we did! it all appeared fine... it was just tight... we however didn't think to check gear selection.. i will pull it out this week and chuck another one in for the time being. |
|
| Author: | JrZook [ Mon Jul 05, 2010 1:17 pm ] |
| Post subject: | Re: Box issue |
Tight!! IF the engine drops by 500rpm as you said it would be freaking tight. Musta had a good grip on that input shaft to turn it over. What gear was it in when it appeared fine? |
|
| Author: | jonno_racing [ Mon Jul 05, 2010 1:30 pm ] |
| Post subject: | Re: Box issue |
nutral. yeah.. its very tight.. we cant get it in2 gear.. i think we might get a nt housing and swap internals.. the issue is there i thnk. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|