| auszookers.com https://auszookers.com/forum/ |
|
| Broke anti wrap bar in half https://auszookers.com/forum/viewtopic.php?f=5&t=13428 |
Page 1 of 1 |
| Author: | mcwilly [ Fri Jul 09, 2010 11:17 am ] |
| Post subject: | Broke anti wrap bar in half |
As the title suggests I recently snapped my sky manufactoring anti wrap bar in half. It snapped the outer tube of the twist and slid. Just wondering if anyones had similar issues or has suggestion how to make it stronger or improve the design?? Thanks |
|
| Author: | BlueSuzy [ Fri Jul 09, 2010 12:18 pm ] |
| Post subject: | Re: Broke anti wrap bar in half |
If you were close, i would of made u a new one.. Make a new one so it doesnt twist that last 100mm, then brace the whole lot. |
|
| Author: | mcwilly [ Sat Jul 10, 2010 12:20 am ] |
| Post subject: | Re: Broke anti wrap bar in half |
So have the internal tube go further in? |
|
| Author: | BlueSuzy [ Sat Jul 10, 2010 2:41 am ] |
| Post subject: | Re: Broke anti wrap bar in half |
NoOb CaD! I think what happened: The solid bar was turning left and right, as well as up and down when extended, bending the tube at the weak point. I would fix it this way, Original solid crossmember end, New bottom end. So no matter where it is in the tube, the tube will not bend. 
Then wait for the next breakage.. |
|
| Author: | alien [ Sat Jul 10, 2010 4:52 am ] |
| Post subject: | Re: Broke anti wrap bar in half |
do that and make the slip bit as long as possible so its contacting more of the inner tube... it was leverage that broke it. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|