| auszookers.com https://auszookers.com/forum/ |
|
| sway bar on calmini arms https://auszookers.com/forum/viewtopic.php?f=5&t=13581 |
Page 1 of 1 |
| Author: | Bucket [ Fri Jul 16, 2010 2:07 am ] |
| Post subject: | sway bar on calmini arms |
Just looking at my sway bar and where it would line up on the calmini arms. Is it ok to swap the ball joints from being on the outside of the sway bar to on the inside? Is there anyway to actual muck up installing the sway bar? |
|
| Author: | BlueSuzy [ Fri Jul 16, 2010 2:08 am ] |
| Post subject: | Re: sway bar on calmini arms |
Should be ok. Sounds simple. |
|
| Author: | atari4x4 [ Fri Jul 16, 2010 2:31 am ] |
| Post subject: | Re: sway bar on calmini arms |
Bucket wrote: Just looking at my sway bar and where it would line up on the calmini arms.
Is it ok to swap the ball joints from being on the outside of the sway bar to on the inside? Is there anyway to actual muck up installing the sway bar?     
|
|
| Author: | Bucket [ Fri Jul 16, 2010 2:58 am ] |
| Post subject: | Re: sway bar on calmini arms |
huh? I'll give it a go anyway. Does 15W-40 engine oil work ok, or is it too thin? |
|
| Author: | Fatzook [ Fri Jul 16, 2010 4:58 am ] |
| Post subject: | Re: sway bar on calmini arms |
Bucket wrote: huh?
I'll give it a go anyway. Does 15W-40 engine oil work ok, or is it too thin? That depends on the condition of your motor
|
|
| Author: | Bucket [ Fri Jul 16, 2010 5:53 am ] |
| Post subject: | Re: sway bar on calmini arms |
Fatzook wrote: Bucket wrote: huh? I'll give it a go anyway. Does 15W-40 engine oil work ok, or is it too thin? That depends on the condition of your motor it'll be alright. Found my manual and it looks like it'll be fine 157000kms and it's not running too bad. |
|
| Author: | shandy92 [ Fri Jul 16, 2010 8:52 am ] |
| Post subject: | Re: sway bar on calmini arms |
Bucket wrote: huh?
I'll give it a go anyway. Does 15W-40 engine oil work ok, or is it too thin? i run that in mine, i got 170xxx, runs good 
|
|
| Author: | gravity_powered [ Fri Jul 16, 2010 9:44 am ] |
| Post subject: | Re: sway bar on calmini arms |
It may not work if they are ball joint type swaybar links. When I had my lift kit fitted to my GV they put the links back on the wrong way around and they both snapped driving home. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|