New water pump should of had new stud's in the box
| auszookers.com https://auszookers.com/forum/ |
|
| Removing studs from water pump https://auszookers.com/forum/viewtopic.php?f=5&t=13956 |
Page 1 of 1 |
| Author: | diver_dingo [ Fri Jul 30, 2010 11:12 pm ] |
| Post subject: | Removing studs from water pump |
Hi guys, i have just replaced a water pump and removed the studs from the old pump the best i could with the tools available (pliers and WD40), but could only get 3 out so the pulley and fan are only held in by 3 bolts at the moment...is there a tool or an easy way to get these studs out? thanks |
|
| Author: | rogerworkman [ Fri Jul 30, 2010 11:15 pm ] |
| Post subject: | Re: Removing studs from water pump |
screw 2 nuts onto the stud and undo the bottom nut |
|
| Author: | BlueSuzy [ Sat Jul 31, 2010 12:07 am ] |
| Post subject: | Re: Removing studs from water pump |
vicegrips, oxy |
|
| Author: | steak_knife [ Sat Jul 31, 2010 4:22 am ] |
| Post subject: | Re: Removing studs from water pump |
New water pump should of had new stud's in the box
|
|
| Author: | diver_dingo [ Sat Jul 31, 2010 5:33 am ] |
| Post subject: | Re: Removing studs from water pump |
steknig wrote: New water pump should of had new stud's in the box
we struggle to get anythin from the monkeys in the stores here, was lucky i found something to fit at all |
|
| Author: | honks [ Sat Jul 31, 2010 9:26 pm ] |
| Post subject: | Re: Removing studs from water pump |
done my water pump yesterday it came with the studs it was a generic pump no brand on the box |
|
| Author: | diver_dingo [ Sat Jul 31, 2010 9:28 pm ] |
| Post subject: | Re: Removing studs from water pump |
the dickhead at the shop must have given me the wrong one then. god damn i hate when that happends. i went to buy a little compressor from an auto shop the other day, and went through 3 hoses and 2 pumps before one was right, then checked the inflator yesterday and it doesnt work, but theyre closed today. pissed off, im going to the dunes today, bloody lucky i tested it all and bloody lucky i have a spare. |
|
| Author: | steak_knife [ Sat Jul 31, 2010 10:39 pm ] |
| Post subject: | Re: Removing studs from water pump |
diver_dingo wrote: the dickhead at the shop must have given me the wrong one then. god damn i hate when that happends. i went to buy a little compressor from an auto shop the other day, and went through 3 hoses and 2 pumps before one was right, then checked the inflator yesterday and it doesnt work, but theyre closed today. pissed off, im going to the dunes today, bloody lucky i tested it all and bloody lucky i have a spare.
It's nice in Brisbane!!! 
You can just use bolt's to hold fan & pulley on, that's what mine has, same same when you think about it.. 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|