| auszookers.com https://auszookers.com/forum/ |
|
| Driveshaft spline https://auszookers.com/forum/viewtopic.php?f=5&t=14115 |
Page 1 of 1 |
| Author: | Moph [ Fri Aug 06, 2010 6:36 am ] |
| Post subject: | Driveshaft spline |
Am pulling my transfer tomorrow to fit a Roctoy ring and 2" JC transfer lift ... with the length of spline I have showing there, can anyone give me an idea what thickness (if any) driveshaft spacer I need? 
About time I put the 2" mounts in ... though vice grips work impressively well! 
|
|
| Author: | finlay113 [ Fri Aug 06, 2010 6:43 am ] |
| Post subject: | Re: Driveshaft spline |
I've got a 10 mm snake racing spacer if that's what you end up needing. Let me know |
|
| Author: | Red89 [ Fri Aug 06, 2010 8:29 am ] |
| Post subject: | Re: Driveshaft spline |
Looks fine as is to me. |
|
| Author: | BlueSuzy [ Fri Aug 06, 2010 8:51 am ] |
| Post subject: | Re: Driveshaft spline |
i run a 30mm spacer. Ruf, Dif is 25/30mm forward. 2'trans lift, but 1'or less lift in springs, spua. |
|
| Author: | Moph [ Fri Aug 06, 2010 9:01 am ] |
| Post subject: | Re: Driveshaft spline |
BlueSuzy wrote: i run a 30mm spacer. Ruf, Dif is 25/30mm forward. 2'trans lift, but 1'or less lift in springs, spua.
Cool - that's about what mine is - RUF, front 1"ish forward, rear 0.5"ish back, 1"ish spring lift, soon-to-be 2" transfer lift. Will put the lift in then have a look at it again. |
|
| Author: | BlueSuzy [ Fri Aug 06, 2010 2:25 pm ] |
| Post subject: | Re: Driveshaft spline |
my rear diff is only about 15mm rearward, so no spacer needed, and had no spline drama's other than the boot tearing on the chassis.. 
I now fixed that by turning the shaft upside down, so now the tailshaft hits the chassis..
|
|
| Author: | daisy [ Fri Aug 06, 2010 7:18 pm ] |
| Post subject: | Re: Driveshaft spline |
two of our zooks run them exactly like that with no spacers. seem to be fine. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|