BlueSuzy wrote:
They look raised.
No height will stop you from hitting the tank. Thats what guards are for.
No height will stop you from hitting the tank. Thats what guards are for.
| auszookers.com https://auszookers.com/forum/ |
|
| is this asking for trouble https://auszookers.com/forum/viewtopic.php?f=5&t=14133 |
Page 1 of 1 |
| Author: | benji [ Fri Aug 06, 2010 2:48 pm ] |
| Post subject: | is this asking for trouble |
the rule stops at 36" and the tyres are 28" would 31s fill the gap ??? or should i drop it a bit |
|
| Author: | BlueSuzy [ Fri Aug 06, 2010 3:00 pm ] |
| Post subject: | Re: is this asking for trouble |
31's will not fill the gap.. 1.5 inches bigger will do fark all. What is your setup? From what i can see, Piss off those shackles with that 2-3" sus lift. They will do you no good! Flex worse than stock. I have done it with mine. Made it a stiff wheel lifting POS. and 3-4" BL! WHY!?? With those tyres, you could run NO lift. With some small trimming only. Your probably running at least 8" of lift there. Excluding tyre size/lift. Your asking for BIG trouble! |
|
| Author: | benji [ Fri Aug 06, 2010 3:07 pm ] |
| Post subject: | Re: is this asking for trouble |
3" and it was on the tub when i got it so ithought id use them they are threaded so they srew on to the studs in the tub and a prick to get off getting rid of the shackles would be a start though cheers |
|
| Author: | BlueSuzy [ Fri Aug 06, 2010 3:10 pm ] |
| Post subject: | Re: is this asking for trouble |
1: Get rid of BL 2: Get rid of Shackles 3: Keep Spring lift. |
|
| Author: | benji [ Fri Aug 06, 2010 3:23 pm ] |
| Post subject: | Re: is this asking for trouble |
yeah i think i knew it was overboard but was after the easy way out, will have to go to work to get the oxy to try get them off with a bit of heat |
|
| Author: | steak_knife [ Fri Aug 06, 2010 8:53 pm ] |
| Post subject: | Re: is this asking for trouble |
BlueSuzy wrote: 1: Get rid of BL
2: Get rid of Shackles 3: Keep Spring lift. No 1 & 2 X 2 |
|
| Author: | lump_a_charcoal [ Sat Aug 07, 2010 1:38 am ] |
| Post subject: | Re: is this asking for trouble |
steknig wrote: BlueSuzy wrote: 1: Get rid of BL 2: Get rid of Shackles 3: Keep Spring lift. No 1 & 2 X 2 X more. |
|
| Author: | benji [ Sat Aug 07, 2010 2:31 am ] |
| Post subject: | Re: is this asking for trouble |
but two inch would be acceptable ??? i need two get it up a bit to try and stop my gas tank from grounding out last time i dropped on it it shattered the floor around the mounts. do these springs look bigger to you guys they have suz002 on them but i wasnt sure if they are raised or not ???? cheers for the advise gentlemen |
|
| Author: | BlueSuzy [ Sat Aug 07, 2010 2:54 am ] |
| Post subject: | Re: is this asking for trouble |
They look raised. No height will stop you from hitting the tank. Thats what guards are for. |
|
| Author: | Fatzook [ Sat Aug 07, 2010 2:56 am ] |
| Post subject: | Re: is this asking for trouble |
BlueSuzy wrote: They look raised.
No height will stop you from hitting the tank. Thats what guards are for.
|
|
| Author: | appsie [ Sat Aug 07, 2010 6:58 am ] |
| Post subject: | Re: is this asking for trouble |
hows that for free advertising 
lose a heap of height mate,thats damn big. and.........add one of these 
|
|
| Author: | benji [ Sat Aug 07, 2010 12:13 pm ] |
| Post subject: | Re: is this asking for trouble |
already done dropped down to 1" , dont think my tank will fit in one of those, when i say gas tank i mean lpg |
|
| Author: | Fatzook [ Sat Aug 07, 2010 12:35 pm ] |
| Post subject: | Re: is this asking for trouble |
benji wrote: already done dropped down to 1" , dont think my tank will fit in one of those, when i say gas tank i mean lpg
Give me the specs. I'll make one fit
|
|
| Author: | benji [ Sat Aug 07, 2010 12:39 pm ] |
| Post subject: | Re: is this asking for trouble |
cheers mate i'll measure it up tomorow |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|