you dont need to use torque spec if your familiar with torquing up bolts on a car/4x4,but if your not I would recommend it!also you should tighten from the center out...don't forget your gasket and goo
| auszookers.com https://auszookers.com/forum/ |
|
| Installing extractors https://auszookers.com/forum/viewtopic.php?f=5&t=14145 |
Page 1 of 1 |
| Author: | zukiduki [ Sat Aug 07, 2010 5:41 am ] |
| Post subject: | Installing extractors |
I'm installing some extractors, just wondering if i need to use a torque wrench or if i just bang em on nice and tight. If i need a torque wrench can anybody forward me the settings |
|
| Author: | 89_tintop [ Sat Aug 07, 2010 6:55 am ] |
| Post subject: | Re: Installing extractors |
there will be some torque setting in the manual for it but i always do them up till they are tight |
|
| Author: | zuk85 [ Sat Aug 07, 2010 7:00 am ] |
| Post subject: | Re: Installing extractors |
intake/ exhuast manifold nuts/bolts- 13.5 to 20 ft-lbs and i guess do them in a sequence so it presses down evenly. |
|
| Author: | unique_seek [ Sat Aug 07, 2010 9:04 am ] |
| Post subject: | Re: Installing extractors |
you dont need to use torque spec if your familiar with torquing up bolts on a car/4x4,but if your not I would recommend it!also you should tighten from the center out...don't forget your gasket and goo
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|