ive had a ball joint fail, now you have
| auszookers.com https://auszookers.com/forum/ |
|
| ball joints https://auszookers.com/forum/viewtopic.php?f=5&t=14302 |
Page 1 of 1 |
| Author: | banga [ Fri Aug 13, 2010 1:00 pm ] |
| Post subject: | ball joints |
this week i got a set of king springs through work couldn't resist they were only $85 a pair and put some vt commo shocks in and also doing my tie rod ends in the vitara today and i thought while i was at it i should do the ball joints went to pull one out and realized it hits the drive shaft. do i have to undo centre nut and release the stub axle from the hub to get the ball joint out or am i looking at it all wrong. |
|
| Author: | royce [ Fri Aug 13, 2010 8:50 pm ] |
| Post subject: | Re: ball joints |
yes |
|
| Author: | steak_knife [ Fri Aug 13, 2010 9:14 pm ] |
| Post subject: | Re: ball joints |
royce wrote: yes
yep.. |
|
| Author: | banga [ Sat Aug 14, 2010 4:06 am ] |
| Post subject: | Re: ball joints |
that sucks poo i didn't want to do that, used to the subaru when you can take them out with out having to take anything else out |
|
| Author: | royce [ Sat Aug 14, 2010 5:04 am ] |
| Post subject: | Re: ball joints |
ive never heard of a vitara needing the balljoints replaced so there you go |
|
| Author: | dmould66 [ Sat Aug 14, 2010 1:33 pm ] |
| Post subject: | Re: ball joints |
ive had a ball joint fail, now you have
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|