| auszookers.com https://auszookers.com/forum/ |
|
| OME suspension question, help needed https://auszookers.com/forum/viewtopic.php?f=5&t=14314 |
Page 1 of 1 |
| Author: | imatt [ Sat Aug 14, 2010 6:30 am ] |
| Post subject: | OME suspension question, help needed |
Hi All, I have just bought a second hand set of OME springs and shockers, when I picked them up the guy said they are the HD version springs, I was hoping they would be standard so I can get more flex. My question is, is it just a case of removing a spring from each pack or is there more involved? The part #'s are: 7R09 7D09 X8A09 x 2 (rear) Any help is greatly appreciated. Cheers Matt |
|
| Author: | lump_a_charcoal [ Sat Aug 14, 2010 7:16 am ] |
| Post subject: | Re: OME suspension question, help needed |
Should be able to, post up a pic of the pack if you can. |
|
| Author: | imatt [ Sat Aug 14, 2010 9:09 am ] |
| Post subject: | Re: OME suspension question, help needed |
Here is some photos of the leaf packs: |
|
| Author: | xedent [ Sat Aug 14, 2010 9:11 am ] |
| Post subject: | Re: OME suspension question, help needed |
The little ones on the bottom are the load leafs, when i had my swb i ran 3 leafs all round and it was good flex, might sag a bit but. |
|
| Author: | imatt [ Sat Aug 14, 2010 9:16 am ] |
| Post subject: | Re: OME suspension question, help needed |
Cheers Xedent, so can I assume that I should be able to just remove what leafs I dont need? Does anyone know how many leafs the standard OME springs have? Cheers Matt |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|