just make sure the bearing's are w/t one's, that have a spacer on em..
brake's are fine to change over, that the way i do it..
| auszookers.com https://auszookers.com/forum/ |
|
| wide track convertion https://auszookers.com/forum/viewtopic.php?f=5&t=14334 |
Page 1 of 1 |
| Author: | jomclean [ Sun Aug 15, 2010 8:12 am ] |
| Post subject: | wide track convertion |
hay guys got some wt diffs to put in my nt just wanting to know will the rear drum braeks change over?. chees joe |
|
| Author: | lump_a_charcoal [ Sun Aug 15, 2010 8:15 am ] |
| Post subject: | Re: wide track convertion |
You talking about the handbrake? |
|
| Author: | steak_knife [ Sun Aug 15, 2010 8:17 am ] |
| Post subject: | Re: wide track convertion |
To retain your transfer h/brake?? The rear's can be swapped over, but you'll have to change the backing plate's, meaning new wheel bearing's. If you run the w/t rear's with out the h/bake attached, the self adjusted won't work properly.. I personally prefer the transfer h/bake to w/t's.. |
|
| Author: | jomclean [ Sun Aug 15, 2010 8:45 am ] |
| Post subject: | Re: wide track convertion |
yes thank steknig was going to change the wheel bearings any way. the wt backing plates are all bent and dinted. and was going to keep the transfer hand brake |
|
| Author: | steak_knife [ Sun Aug 15, 2010 8:52 am ] |
| Post subject: | Re: wide track convertion |
just make sure the bearing's are w/t one's, that have a spacer on em.. brake's are fine to change over, that the way i do it..
|
|
| Author: | jomclean [ Sun Aug 15, 2010 9:09 am ] |
| Post subject: | Re: wide track convertion |
ok thanks |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|