| auszookers.com https://auszookers.com/forum/ |
|
| cutting gaurds https://auszookers.com/forum/viewtopic.php?f=5&t=14372 |
Page 1 of 1 |
| Author: | unique_seek [ Mon Aug 16, 2010 10:53 am ] |
| Post subject: | cutting gaurds |
Hi all, Looking at putting some TJ flares on,but want to cut the guards to suit,I have done a bit of searching but all the links end up dead or out of action..anyone have any info on cutting the guards and what methods are used to rebuild the inner guard. Cheers |
|
| Author: | BlueSuzy [ Mon Aug 16, 2010 1:16 pm ] |
| Post subject: | Re: cutting gaurds |
Grinder, Welder, Sheetmetal, Patience. Paint* That is all. *Optional |
|
| Author: | 31zook [ Mon Aug 16, 2010 6:20 pm ] |
| Post subject: | Re: cutting gaurds |
lotsa time, or you will get dodge. make sure you grab a flappy disk mark where you want to cut and clean all the paint off of there. othere wise you will have a crap time tring to low amp weld contaminated steel.... i know things will be different when i cut my front guards 
|
|
| Author: | unique_seek [ Tue Aug 17, 2010 8:24 am ] |
| Post subject: | Re: cutting gaurds |
so you guys just cut the guard to suit and then fill the gap with some sheet..tack...clean....paint....mount new flares...sounds too easy???haha any one after a set of coily steel flares when I'm done??? |
|
| Author: | Joe [ Tue Aug 17, 2010 8:35 am ] |
| Post subject: | Re: cutting gaurds |
unique_seek wrote: so you guys just cut the guard to suit and then fill the gap with some sheet..tack...clean....paint....mount new flares...sounds too easy???haha
any one after a set of coily steel flares when I'm done??? This guy does |
|
| Author: | unique_seek [ Tue Aug 17, 2010 9:34 am ] |
| Post subject: | Re: cutting gaurds |
ok I found what I was looking for...http://www.izook.com/tech/samurai/body/ ... lwells.htm Thanks guys |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|