auszookers.com
https://auszookers.com/forum/

gear box whine i think
https://auszookers.com/forum/viewtopic.php?f=5&t=14792
Page 1 of 1

Author:  honks [ Fri Sep 03, 2010 7:25 pm ]
Post subject:  gear box whine i think

my 95 sierra has a pretty noisey whine to it not that bad under accelration but terrible under decceleration sounds sort of metalic noise but it goes away when i apply the clutch would this be my gear box it has 227 000 kms on it
thanks

Author:  whincup [ Fri Sep 03, 2010 9:37 pm ]
Post subject:  Re: gear box whine i think

is the noise consistent with the engine revs or car speed? as in, if you change a gear does it become slightly louder or quieter, or the same regardless of the RPM?

i would be checking oil levels first... or try replacing oil completely. might at least lessen the noise...

Author:  TZAR [ Fri Sep 03, 2010 9:38 pm ]
Post subject:  Re: gear box whine i think

probably transfer case noise. very common

Author:  honks [ Sat Sep 04, 2010 2:33 am ]
Post subject:  Re: gear box whine i think

same noise regardless of the revs or gears

Author:  teresap989 [ Sat Sep 04, 2010 3:03 am ]
Post subject:  Re: gear box whine i think

honks wrote:
same noise regardless of the revs or gears

i would be checking oil levels first... or try replacing oil completely. might at least lessen the noise...


__________________
watch free movies online

Author:  honks [ Sat Sep 04, 2010 3:06 am ]
Post subject:  Re: gear box whine i think

gear box oil is fine done it a couple of months ago will check tranfer oil

Author:  steak_knife [ Sat Sep 04, 2010 3:16 am ]
Post subject:  Re: gear box whine i think

honks wrote:
gear box oil is fine done it a couple of months ago will check tranfer oil


That mean's nothing if you've been through water, would pay to at least check it..

Author:  honks [ Sat Sep 04, 2010 4:12 am ]
Post subject:  Re: gear box whine i think

i haven't been through any water just checked transfer oil it seemed a little low (had to put finger in and around the filler hole to feel any oil ) i dropped it and put some new stuff in there will have to c how it goes now.when i tipped the old oil into a 1.5ltr bottle it was under half way up so guess it had around 600ml-700ml of oil in it so would this have any thing to do with the noise or could it be a bearing related problem

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/