| auszookers.com https://auszookers.com/forum/ |
|
| help coily transfer case not engaging https://auszookers.com/forum/viewtopic.php?f=5&t=14837 |
Page 1 of 1 |
| Author: | eli12 [ Sun Sep 05, 2010 3:38 am ] |
| Post subject: | help coily transfer case not engaging |
hi all i just bought a 98 coily and love it! but prob is it wont go into 4 low. 4 hi is fine. seems i cant get across to the 4 low gate. i got it off an old lady 1 owner so prob has never used off road. has any1 got any ideas why this could be? |
|
| Author: | jonno_racing [ Sun Sep 05, 2010 3:39 am ] |
| Post subject: | Re: help coily transfer case not engaging |
not sure why.. but pretty much every one with a coily puts a wt case in it.. great mod imo |
|
| Author: | eli12 [ Sun Sep 05, 2010 3:48 am ] |
| Post subject: | Re: help coily transfer case not engaging |
cheers yeh am looking to mod down the track but at this point am to skint so was hoping to get try and get the original sorted |
|
| Author: | 89_tintop [ Sun Sep 05, 2010 3:51 am ] |
| Post subject: | Re: help coily transfer case not engaging |
Where in brissie are you?? |
|
| Author: | Lockie666 [ Sun Sep 05, 2010 4:14 am ] |
| Post subject: | Re: help coily transfer case not engaging |
Try rocking it forwards in gear then backwards... It's deffo not the hubs if you can get it in 4 high |
|
| Author: | Joe [ Sun Sep 05, 2010 4:16 am ] |
| Post subject: | Re: help coily transfer case not engaging |
Not too sure but do coilys have the little transfer lever bush thingo??? |
|
| Author: | lump_a_charcoal [ Sun Sep 05, 2010 5:39 am ] |
| Post subject: | Re: help coily transfer case not engaging |
No, they have a different, pushrod type setup I think. I would check the linkage thingo and make sure it isn't loose or something. |
|
| Author: | eli12 [ Sun Sep 05, 2010 6:10 am ] |
| Post subject: | Re: help coily transfer case not engaging |
yeh i tried rockin it backwards and forwards. nah the linkage isnt loose just wont slip across into 4 low. has any1 heard of the tranfer case fail in these? im in hawthorne |
|
| Author: | ZookZilla96 [ Sun Sep 05, 2010 7:08 am ] |
| Post subject: | Re: help coily transfer case not engaging |
hey, my coily had to same problem when i started takin it out.. i just drove around for abit in 4 hi and then just used abit of wiggling and monovaring and it slid straight in.. mine has an anouying problem of slipping out to Neutral when under alot of stress.. its good in ways but shits you off when half way over a big rut/rock. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|