auszookers.com
https://auszookers.com/forum/

swapping coily diff centre
https://auszookers.com/forum/viewtopic.php?f=5&t=15042
Page 1 of 1

Author:  Ridge [ Sun Sep 12, 2010 3:13 am ]
Post subject:  swapping coily diff centre

are coily rear diff centers interchangeable with 1.3L nt centers?
I may be converting my car back to stock and this would be easier then pulling the auto locker out.

Author:  steak_knife [ Sun Sep 12, 2010 3:15 am ]
Post subject:  Re: swapping coily diff centre

I think thay are, could be wrong tho, front's a re different..

Author:  BlueSuzy [ Sun Sep 12, 2010 3:16 am ]
Post subject:  Re: swapping coily diff centre

yes.

They should be the same ratio too. 3.9.

Author:  steak_knife [ Sun Sep 12, 2010 3:17 am ]
Post subject:  Re: swapping coily diff centre

BlueSuzy wrote:
yes.

They should be the same ratio too. 3.9.


:? same as N/t?? :?

i was under the impression thay were 3.7's.. :?

Author:  BlueSuzy [ Sun Sep 12, 2010 3:25 am ]
Post subject:  Re: swapping coily diff centre

1.3 wt 3.7

1.3 nt 3.9

Author:  Ridge [ Sun Sep 12, 2010 3:34 am ]
Post subject:  Re: swapping coily diff centre

yeah the coilys are a 3.9 ratio.
I have a nt centre in the shed to try out now, thanks

Author:  bigrig91 [ Sun Sep 12, 2010 3:35 am ]
Post subject:  Re: swapping coily diff centre

wanna off load your auto locker?

Author:  Ridge [ Sun Sep 12, 2010 3:40 am ]
Post subject:  Re: swapping coily diff centre

bigrig91 wrote:
wanna off load your auto locker?


Not at the moment. i may have a potential buyer for the car coming round for a look soon. depending on their offer, i may sell the car as is or strip it back to stock, then advertise the good bits here.

Author:  jonno_racing [ Sun Sep 12, 2010 10:21 am ]
Post subject:  Re: swapping coily diff centre

bigrig91 wrote:
wanna off load your auto locker?


i might... soon.

Author:  LAY80N [ Mon Sep 13, 2010 8:05 am ]
Post subject:  Re: swapping coily diff centre

You should be able to swap the centres. They are slighly different appearance from memory, but should work.

Layto....

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/