auszookers.com
https://auszookers.com/forum/

how much would u pull from standard rev's wiring?
https://auszookers.com/forum/viewtopic.php?f=5&t=15456		 Page 1 of 1
Author:  jonno_racing [ Tue Sep 28, 2010 9:51 am ]
Post subject:  how much would u pull from standard rev's wiring?
i am about to make up a bracket for my reversing lights, i was thinking about 2x55w globes, will this be 2much for the standard wiring? i dont realy want to go though the extra pain of a relay and running wires up the car etc.
Author:  royce [ Tue Sep 28, 2010 9:58 am ]
Post subject:  Re: how much would u pull from standard rev's wiring?
1 x 55w is too much, fit a relay or get led lights
Author:  ajsr [ Tue Sep 28, 2010 9:59 am ]
Post subject:  Re: how much would u pull from standard rev's wiring?
LED
Author:  Scrawny [ Tue Sep 28, 2010 10:14 am ]
Post subject:  Re: how much would u pull from standard rev's wiring?
Relay!! :twisted:
Author:  whincup [ Tue Sep 28, 2010 10:27 am ]
Post subject:  Re: how much would u pull from standard rev's wiring?
both!!!
Author:  stockman [ Tue Sep 28, 2010 10:45 am ]
Post subject:  Re: how much would u pull from standard rev's wiring?
dolphin torch
Author:  steak_knife [ Tue Sep 28, 2010 11:11 am ]
Post subject:  Re: how much would u pull from standard rev's wiring?
Sheep.
Author:  appsie [ Tue Sep 28, 2010 12:13 pm ]
Post subject:  Re: how much would u pull from standard rev's wiring?
in my rear bar build thread a few months ago you will see that i mounted a 55w spotty.it was done through a realay etc to try stop damage but after only a few weeks the light was staying on,i have power to the back of car at all times so im guessing i done a reverse switch allready even trying to do it properly.

anyway in my opinion 1 is plenty the light it puts out is crazy,mines on the drivers side
Author:  christover1 [ Tue Sep 28, 2010 1:13 pm ]
Post subject:  Re: how much would u pull from standard rev's wiring?
I ran 1 x 55watt spotty, and the the 2 stock lights on my zook reverse for ages, no obvious issues.
But I didn't have an LED option then.
I say go LED directly from rev wires
Author:  BlueSuzy [ Tue Sep 28, 2010 9:43 pm ]
Post subject:  Re: how much would u pull from standard rev's wiring?
I run 2 driving lights as reverse. Blew the switch within days.

I now run a relay with the reverse switch.
Author:  Proxy [ Mon Oct 04, 2010 1:48 pm ]
Post subject:  Re: how much would u pull from standard rev's wiring?
wow i'm glad i read this i am running 2 55w h3 units on the back off the standard rev light wires, guess i better install a relay then
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/