Fitting up a just_cruising transfer lift kit at the moment ... +40 above standard, like this photo I've pinched from an old post of his. Have got a Roctoy ring on there too with 2" BL and can't get the passenger side mount in ... the Roctoy ring hits the driver's side of the tunnel about 5mm shy of being able to slide in the smaller of the two lift blocks.
Can I safely shave 5-10mm off the mount on that side, 'clocking' the transfer down slightly on the passenger side? Would prefer to do that that take meat off the ring.
Also didn't realise that I should have marked the flanges when I removed them from the transfer. I take it this isn't really likely to cause too many problems?
just_cruizin wrote:
