Cam belt, front crank seal, thermostat, rad flush..
I could keep going..
| auszookers.com https://auszookers.com/forum/ |
|
| What Engine????? https://auszookers.com/forum/viewtopic.php?f=5&t=16189 |
Page 1 of 1 |
| Author: | mudzookacoatsy [ Sun Oct 24, 2010 9:37 am ] |
| Post subject: | What Engine????? |
hey all, checked my motor the other day at work and didnt like wat i found, i have a very very minor leaking head gasket and the compersion is down on the two middle pistons. 180psi on tha two end ones and 125psi on the two middle ones . is that bad ???? is it cheaper and easyer to just get another motor out of a zook or swift barina ect. or rebuild mine? |
|
| Author: | LittleJeep [ Sun Oct 24, 2010 9:46 am ] |
| Post subject: | Re: What Engine????? |
it would be cheaper to change head gasket than to change the motor. a lot less stuffin around! and cheaper of cource. |
|
| Author: | mudzookacoatsy [ Sun Oct 24, 2010 9:49 am ] |
| Post subject: | Re: What Engine????? |
ok but wat about tha compresion could that be part of tha head gasket or somwthing else? |
|
| Author: | steak_knife [ Sun Oct 24, 2010 10:00 am ] |
| Post subject: | Re: What Engine????? |
mudzookacoatsy wrote: ok but wat about tha compresion could that be part of tha head gasket or somwthing else?
More than likely the gasket, get the head serviced while it's off or get a good 2nd hand one.. |
|
| Author: | mudzookacoatsy [ Sun Oct 24, 2010 10:08 am ] |
| Post subject: | Re: What Engine????? |
o ok ill keep that in mind any thing else that i should do when its apart ? |
|
| Author: | steak_knife [ Sun Oct 24, 2010 7:40 pm ] |
| Post subject: | Re: What Engine????? |
Cam belt, front crank seal, thermostat, rad flush.. I could keep going..
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|