| auszookers.com https://auszookers.com/forum/ |
|
| fuel problems https://auszookers.com/forum/viewtopic.php?f=5&t=16523 |
Page 1 of 1 |
| Author: | suzukilwb [ Sat Nov 06, 2010 6:49 am ] |
| Post subject: | fuel problems |
i have a 1.3L motor and i got a new fuel pump. i put it all in new falter on it and nothing. so what i did was got a bit of hose and put it in a contaner of fuel and its not sucking any fule at all  what could have gone wrong when i put it in??
there is a breather hose facing down from the fuel pump whats that for as there is nothing attached to it would that matter?? |
|
| Author: | steak_knife [ Sat Nov 06, 2010 6:57 am ] |
| Post subject: | Re: fuel problems |
Look on the ground under the eng & look for a lil push rod, they fall out if you don't know they are there.... |
|
| Author: | suzukilwb [ Sat Nov 06, 2010 7:06 am ] |
| Post subject: | Re: fuel problems |
i had a look could i miss it i looked around the oil patch |
|
| Author: | steak_knife [ Sat Nov 06, 2010 7:52 am ] |
| Post subject: | Re: fuel problems |
could be hiding in the gap of the starter, could of rolled away.. But the fuel pump will not work with out it.. |
|
| Author: | suzukilwb [ Sat Nov 06, 2010 8:26 am ] |
| Post subject: | Re: fuel problems |
can i take it off and see if its in there?? sorry for the stupied questions i dont know much about it |
|
| Author: | steak_knife [ Sat Nov 06, 2010 8:37 am ] |
| Post subject: | Re: fuel problems |
Why not, just take it off carefully, just in case it is, but I doubt it will be.. |
|
| Author: | christover1 [ Sat Nov 06, 2010 8:52 am ] |
| Post subject: | Re: fuel problems |
I have done that before, quite annoying |
|
| Author: | suzukilwb [ Sat Nov 06, 2010 9:44 am ] |
| Post subject: | Re: fuel problems |
ok cheers guys if its not would a 1L one work??? and what size is i just cm will do? |
|
| Author: | want33s [ Sat Nov 06, 2010 8:21 pm ] |
| Post subject: | Re: fuel problems |
suzukilwb wrote: ok cheers guys if its not would a 1L one work??? and what size is i just cm will do?
No 1.0 is different setup. The pushrod is about 55x8mm off the top of my head. I have one here I can send if you need it. |
|
| Author: | suzukilwb [ Sun Nov 07, 2010 8:42 am ] |
| Post subject: | Re: fuel problems |
well pulled it out today and pulled out the rod it looked ok put it back in tourned over the motor to make sure it gos in and out and it dose |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|