| auszookers.com https://auszookers.com/forum/ |
|
| what could this noise be(jimny) https://auszookers.com/forum/viewtopic.php?f=5&t=16606 |
Page 1 of 1 |
| Author: | matchbox [ Tue Nov 09, 2010 6:50 am ] |
| Post subject: | what could this noise be(jimny) |
Hi all, I have a 99 jimny with the 13bb engine 190,000ks, I get this noise through the drive system when you release the clutch in neutral, it gets this ticking rough bearing noise, when you engage the clutch it goes qiet, im not familar with suzuki and wonder if theres any ideas, is there a spigot bearing or some thing that can be replaced while i do the clutch or is it common g/box issue thanks luke |
|
| Author: | steak_knife [ Tue Nov 09, 2010 7:27 am ] |
| Post subject: | Re: what could this noise be(jimny) |
Could be g/box input shaft bearing could be G/box out of oil.. |
|
| Author: | matchbox [ Tue Nov 09, 2010 7:48 am ] |
| Post subject: | Re: what could this noise be(jimny) |
oils good, |
|
| Author: | steak_knife [ Tue Nov 09, 2010 7:51 am ] |
| Post subject: | Re: what could this noise be(jimny) |
How loud is it, just a noise or a rumble?? |
|
| Author: | matchbox [ Tue Nov 09, 2010 8:20 am ] |
| Post subject: | Re: what could this noise be(jimny) |
tickity rumble, you have to listen for it. but def a new noise |
|
| Author: | squizzytaylor [ Wed Nov 10, 2010 4:58 am ] |
| Post subject: | Re: what could this noise be(jimny) |
Throw out bearing. |
|
| Author: | steak_knife [ Wed Nov 10, 2010 6:47 am ] |
| Post subject: | Re: what could this noise be(jimny) |
squizzytaylor wrote: Throw out bearing.
It would change pitch when the peddle was depressed.. hard to tell with out hearing it.. What part of bris you in?? |
|
| Author: | dm90 [ Wed Nov 10, 2010 7:09 am ] |
| Post subject: | Re: what could this noise be(jimny) |
mine does the same, i thought it was the thrust bearing and when i got a new clutch the noise was gone, but it has started again but is much quieter now, i mentioned it to suzistore and they think its the gearbox and isnt a problem. |
|
| Author: | matchbox [ Wed Nov 10, 2010 7:18 am ] |
| Post subject: | Re: what could this noise be(jimny) |
yea its not the throw out bearing its when the clutch isnt enganged, well ive also got a spiggot bearing orders aswell, and will find out this wkend when i pull the g/box out to do the clutch |
|
| Author: | matchbox [ Sun Nov 14, 2010 4:27 am ] |
| Post subject: | Re: what could this noise be(jimny) |
found the noise, spiggot bearing siezed in back of flywheel, which has chewed the end of the input shaft out, so now gear box is apart and am gunna machine input shaft, any one know how much a g/box rebuild kit is worth |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|