| auszookers.com https://auszookers.com/forum/ |
|
| g16b https://auszookers.com/forum/viewtopic.php?f=5&t=16811 |
Page 1 of 1 |
| Author: | Pauly [ Mon Nov 15, 2010 11:14 pm ] |
| Post subject: | g16b |
hey looking at selling my g16b engine jjust wondering what there worth. will either be for sale as is ( head off etc etc, comes with inlet, injectors, clutch most of the bits) or ill put it back together with a new head gasket and water pump and timing belt kit...? whats it worth either way |
|
| Author: | Pauly [ Tue Nov 16, 2010 2:33 am ] |
| Post subject: | Re: g16b |
just really cbf spending 4k to make it efi and awesome. rather spend 400 and make it a little faster... |
|
| Author: | 5ierra [ Tue Nov 16, 2010 3:05 am ] |
| Post subject: | Re: g16b |
Havent done it myself but your probably looking anywhere from $800 to $1500 if you do it yourself and up to and including $4000 if you get smeone else to find the engine and install it. |
|
| Author: | Pauly [ Tue Nov 16, 2010 3:07 am ] |
| Post subject: | Re: g16b |
yeah i know all bout the price of doing the conversion. thats why im deciding not to go ahead, i was guna rebuild the engine etc etc, but its guna be too dear so im guna sell the g16b i wanted to know what there worth in pieces vs together... |
|
| Author: | Fatzook [ Tue Nov 16, 2010 3:30 am ] |
| Post subject: | Re: g16b |
Pauly wrote: yeah i know all bout the price of doing the conversion. thats why im deciding not to go ahead, i was guna rebuild the engine etc etc, but its guna be too dear so im guna sell the g16b i wanted to know what there worth in pieces vs together...
Well knowing that you have pulled it appart I would not offer you top $$ anymore. If it were unmolested you could get $1K for it quite easily. Do you have ECU and loom? |
|
| Author: | 5ierra [ Tue Nov 16, 2010 3:38 am ] |
| Post subject: | Re: g16b |
oppps, sorry didnt read your question properly, my bad. |
|
| Author: | Pauly [ Tue Nov 16, 2010 3:40 am ] |
| Post subject: | Re: g16b |
i dont care as long as i get what i payd for it im happy $300 as is. or ill put it back together with new head gasket and timing belt and pump for prob $600. i wanted pull it apart to make sure it was all good for my conversion but its guna cost me too much for what its worth... |
|
| Author: | Pauly [ Tue Nov 16, 2010 3:41 am ] |
| Post subject: | Re: g16b |
no ecu or loom tho.. |
|
| Author: | Fatzook [ Tue Nov 16, 2010 3:44 am ] |
| Post subject: | Re: g16b |
$300? I'll take it. I'll PM you. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|