carby was done a month ago and i have cleaned jets and fuel etc etc. doesnt have points bruz electronic ign here
| auszookers.com https://auszookers.com/forum/ |
|
| engine problem g13b carb https://auszookers.com/forum/viewtopic.php?f=5&t=16817 |
Page 1 of 1 |
| Author: | Pauly [ Tue Nov 16, 2010 3:10 am ] |
| Post subject: | engine problem g13b carb |
once again there is a issue with my car. ive searched the forums but no posts regarding this issue: after running 14* of timming running on 98 octane fuel ( has been running like that for 3 weeks ish) i was on the beach and it started to ping a little then after that its been backfiring on deceleration and sometimes (normally when hot) not idling properly.... ive noticed the carby plunger not as freely moving as normal but yeah ive back the timing back to 8* and its still doing this any ideas????? ive had the carb adjustd but still noo good... |
|
| Author: | Kermy87 [ Tue Nov 16, 2010 3:22 am ] |
| Post subject: | Re: engine problem g13b carb |
Strip the carby down and cleane it, blow out the jets, clean or replace your plugs, probably got crap in the carby, try that ,will probably fix ur idle problem, also clean the points under the dizzy cap |
|
| Author: | Pauly [ Tue Nov 16, 2010 3:31 am ] |
| Post subject: | Re: engine problem g13b carb |
carby was done a month ago and i have cleaned jets and fuel etc etc. doesnt have points bruz electronic ign here
|
|
| Author: | Pauly [ Tue Nov 16, 2010 3:32 am ] |
| Post subject: | Re: engine problem g13b carb |
im thinking the timing belt has jumped a tooth and the plunger has become sticky..... opinions? |
|
| Author: | Kermy87 [ Tue Nov 16, 2010 3:39 am ] |
| Post subject: | Re: engine problem g13b carb |
What motor you Running??? |
|
| Author: | Pauly [ Tue Nov 16, 2010 3:44 am ] |
| Post subject: | Re: engine problem g13b carb |
g13b on rego papers but i think its a g13a 1.3 sohc carby snot box in a 1991 sierra has no points cause when i did the rotor button and cap... i was like woop woop
|
|
| Author: | Kermy87 [ Tue Nov 16, 2010 3:59 am ] |
| Post subject: | Re: engine problem g13b carb |
Ha nice, yeah, your probably on the ball, strip the timing gear cover and check timing belt hasn't jumped a tooth, otherwise without laying a spanner or listining to it probably can't help ya too much more |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|