| auszookers.com https://auszookers.com/forum/ |
|
| diff seal https://auszookers.com/forum/viewtopic.php?f=5&t=17392 |
Page 1 of 1 |
| Author: | burls [ Thu Dec 09, 2010 10:33 am ] |
| Post subject: | diff seal |
need to change my rear diff pinion seal, what torque should I do the output shaft nut up to? |
|
| Author: | rick1970 [ Thu Dec 09, 2010 4:21 pm ] |
| Post subject: | Re: diff seal |
If your torque the nut up as such chances are you will change the preload on the pinion bearings and change the position of the pinion compared to the crownwheel. Just tighten the nut enough to remove any end float in the pinion (so the crush tube dosn't 'crush' any more than it already has) and lock the nut in place. |
|
| Author: | burls [ Fri Dec 10, 2010 1:17 am ] |
| Post subject: | Re: diff seal |
yeah thats what I thought thanks |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|