| auszookers.com https://auszookers.com/forum/ |
|
| Custom Spring's https://auszookers.com/forum/viewtopic.php?f=5&t=17648 |
Page 1 of 1 |
| Author: | sbbunno [ Mon Dec 20, 2010 12:23 pm ] |
| Post subject: | Custom Spring's |
hey guys wondering where about's in perth or south WA you can get custom springs made. i wont to get them made 50 - 75mm longer, my shackles are near straight wile jus sitting there. 
yes i have serched but couldnt find any in these area's. also i dont wont to get other springs as i dont really feel like relocating the diff. cheers scott 
|
|
| Author: | atari4x4 [ Mon Dec 20, 2010 12:33 pm ] |
| Post subject: | Re: Custom Spring's |
try http://www.westraliasprings.com.au/ or http://www.industrialsprings.com.au/contact.htm in SA |
|
| Author: | BlueSuzy [ Mon Dec 20, 2010 8:38 pm ] |
| Post subject: | Re: Custom Spring's |
A main and full length second is all you will need. Then use your existing to fill underneath. |
|
| Author: | sbbunno [ Mon Dec 20, 2010 9:49 pm ] |
| Post subject: | Re: Custom Spring's |
ok guys thanks |
|
| Author: | Red89 [ Tue Dec 21, 2010 9:49 am ] |
| Post subject: | Re: Custom Spring's |
I got my first set through Westralia springs however the 2nd set I needed they no longer did custom leaves under 8mm thick ( Sierra's are 6mm I think ) They could order it in but that was going to add $80 each leaf. So the 2nd set I got made at Suspension Man in Bellevue, not cheap at about $90 per leaf. Make sure you have all your measurements, dont just walk in and say you want a leaf that is a couple inches longer. You need the straight across eye to eye measurement, the bush size, the eye to pin measurement for each end following the curve, the camber/height measurement and material thickness needed. Also dont forget to tell them it is for a vehicle weighing around 1000kg, I forgot to do this the second time and he made them too stiff 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|