I want to secure this flap I made to hold my GPS mount. Any ideas?
| auszookers.com https://auszookers.com/forum/ |
|
| How to secure this https://auszookers.com/forum/viewtopic.php?f=5&t=17916 |
Page 1 of 1 |
| Author: | Che [ Sat Jan 01, 2011 10:44 pm ] |
| Post subject: | How to secure this |
I want to secure this flap I made to hold my GPS mount. Any ideas?
|
|
| Author: | atari4x4 [ Sat Jan 01, 2011 10:49 pm ] |
| Post subject: | Re: How to secure this |
some self tappers through both bits of plastic using a stumpy screw driver, or liquid nails? |
|
| Author: | want33s [ Sat Jan 01, 2011 10:50 pm ] |
| Post subject: | Re: How to secure this |
SIKAFLEX 291 |
|
| Author: | foonji [ Sat Jan 01, 2011 10:53 pm ] |
| Post subject: | Re: How to secure this |
You must have the same Tomtom as I, it fits perfect in that little compartment. |
|
| Author: | Chop [ Sat Jan 01, 2011 10:58 pm ] |
| Post subject: | Re: How to secure this |
Does the tomtom take much pressure to clip into the holder and off the holder? maybe araldite down the sides and bottom, then once set sikaflex over the top and fill the top with it? |
|
| Author: | Che [ Sat Jan 01, 2011 10:58 pm ] |
| Post subject: | Re: How to secure this |
Mine is the perfect width, just a few mm too tall (its a 250XL I think). Tried to cut out a space to fit it in the compartment, but just can't get it to fit and look nice. I got some Sikaflex 221. I'll try that if bunnings can gimmie a spare nozzle. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|