mine did that when the top hose split and it was running out of coolant
| auszookers.com https://auszookers.com/forum/ |
|
| Temp gauge movement https://auszookers.com/forum/viewtopic.php?f=5&t=18028 |
Page 1 of 1 |
| Author: | Chop [ Thu Jan 06, 2011 12:06 am ] |
| Post subject: | Temp gauge movement |
Noticed this morning my temp gauge has started moving under revs, as i accelerate it drops. Its not getting hot, it sits in its normal position but when i'm getting up to speed and hitting 70-100 the needle drops if i take my foot off and the revs and speed die down the the needle goes back up? Anyone seen this before? |
|
| Author: | royce [ Thu Jan 06, 2011 12:15 am ] |
| Post subject: | Re: Temp gauge movement |
mine did that when the top hose split and it was running out of coolant
|
|
| Author: | royce [ Thu Jan 06, 2011 12:15 am ] |
| Post subject: | Re: Temp gauge movement |
Could be your fan isnt locking up anymore either |
|
| Author: | Kermy87 [ Thu Jan 06, 2011 12:22 am ] |
| Post subject: | Re: Temp gauge movement |
Hey mate, check the temp sencor on the manifold , either the female spade terminal wire is loose on the sencor( get a pair of pliers and crimp it a bit and put it on again). ... Or the actual sencor has a wigly terminal on it, pull it out put in in a vice ( not on the thread) on the flat nut and give it a lil punch with a hammer and chisel and tighten it up), try that,,, if it's rooted super cheap auto barn carry them for like $15 hope this helps cheers kermy87 |
|
| Author: | Chop [ Thu Jan 06, 2011 12:26 am ] |
| Post subject: | Re: Temp gauge movement |
Well the coolant level and all the hose are good at the moment. My sierra used to do it with the fuel gauge but that stopped when i change senders. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|