auszookers.com
https://auszookers.com/forum/

sierra window winder removal
https://auszookers.com/forum/viewtopic.php?f=5&t=18313
Page 1 of 1

Author:  tom__ [ Mon Jan 17, 2011 1:11 am ]
Post subject:  sierra window winder removal

Searched with no luck.

Can anyone tell me how to remove the window winder from the inside of the door on the sierra.

Thanks

Author:  christover1 [ Mon Jan 17, 2011 1:49 am ]
Post subject:  Re: sierra window winder removal

It has a funny clip thing behind the plastic sleeve.
It locks into 2 grooves across the spline.
It should pull out fairly easy,
but it can disappear into the blue yonder and never be seen again :)

Author:  christover1 [ Mon Jan 17, 2011 2:01 am ]
Post subject:  Re: sierra window winder removal

Image

Author:  zook95 [ Mon Jan 17, 2011 2:01 am ]
Post subject:  Re: sierra window winder removal

use pliers or something to get the circlip off and it will just pull of then

Author:  atari4x4 [ Mon Jan 17, 2011 2:04 am ]
Post subject:  Re: sierra window winder removal

use the seat belt or a the edge of a tee shirt & slide the edge around between the door trim & the winder, yes it will fly across the shed.

Author:  tom__ [ Mon Jan 17, 2011 2:08 am ]
Post subject:  Re: sierra window winder removal

i couldn't see a circlip. will have another look in a sec as the car is at work.

Author:  tom__ [ Mon Jan 17, 2011 2:18 am ]
Post subject:  Re: sierra window winder removal

it appears there is no circlip there or even anywhere that on would sit. The handle just came straight off the spline with some gentle persuading.

Thanks for the help anyway.

Author:  shakes [ Mon Jan 17, 2011 8:12 am ]
Post subject:  Re: sierra window winder removal

christover1 wrote:
but it can disappear into the blue yonder and never be seen again :)


hence known as a jesus clip..
"jesus where the hell did that go?"

Author:  cairns27 [ Tue Jan 18, 2011 2:55 pm ]
Post subject:  Re: sierra window winder removal

a use an old T shirt or similar the clip should stay with the rag when removed you might need a small screw driver to get the rag under the plastic doever the pointer bits of the clip normally face towards the handle

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/