| auszookers.com https://auszookers.com/forum/ |
|
| Will a G16A 8v head bolt sraight onto a G13A 8v Block? https://auszookers.com/forum/viewtopic.php?f=5&t=18383 |
Page 1 of 1 |
| Author: | Bullseye [ Wed Jan 19, 2011 10:36 pm ] |
| Post subject: | Will a G16A 8v head bolt sraight onto a G13A 8v Block? |
Hey there people! Does anyone know the answer to the question above? In short, looking to build a race engine for a class with the max capacity of 1340cc, only allowed single camshaft and no more than 2valve's per cylinder. Thinking of going the Suzuki engine because of the alloy block for lightness, where most other's seem to all be cast blocks. So wondering if a G16a head will bolt onto a G13a block to get the bigger intake valve's! Thanks in advance. |
|
| Author: | Damo [ Wed Jan 19, 2011 11:40 pm ] |
| Post subject: | Re: Will a G16A 8v head bolt sraight onto a G13A 8v Block? |
Bullseye wrote: Hey there people!
Does anyone know the answer to the question above? In short, looking to build a race engine for a class with the max capacity of 1340cc, only allowed single camshaft and no more than 2valve's per cylinder. Thinking of going the Suzuki engine because of the alloy block for lightness, where most other's seem to all be cast blocks. So wondering if a G16a head will bolt onto a G13a block to get the bigger intake valve's! Thanks in advance. Yep, it will. |
|
| Author: | shep [ Wed Jan 19, 2011 11:47 pm ] |
| Post subject: | Re: Will a G16A 8v head bolt sraight onto a G13A 8v Block? |
g13 has a square tooth timing belt and i am sure that the g16 has a round tooth so you may need to change pulleys. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|