haha yep i think i better because i was just going to tidy it all up respray it ect and then take it in...
i might just give em a call 1st, cheers, royce
| auszookers.com https://auszookers.com/forum/ |
|
| engineer in brisbane https://auszookers.com/forum/viewtopic.php?f=5&t=1850 |
Page 1 of 1 |
| Author: | islandvitara [ Sat Mar 15, 2008 7:48 pm ] |
| Post subject: | engineer in brisbane |
where do you suggest i get my sierra engineer approved? or would i even have to? i have an 86 SWB sierra hi-top but i choped the hi-top off as im changing it to a softop - i bought the B-pillar that goes across between the doors above the 2 front seats, just like the softops i just gota weld up the seems where i cut the roof off. do i have to get it engineer approved or will it be fine? im trying to get it to look as close as possible to a factory softop as possible. im doing a full re-spray afterwards so it'll look pretty neat. but if i do have to get a mod plate for it where should i go? im in the brisbane area (mt gravatt) thanks islandvit |
|
| Author: | royce [ Sat Mar 15, 2008 8:18 pm ] |
| Post subject: | Re: engineer in brisbane |
you would probably have to get a panelvan to ute modplate or convertable modplate, though soft top and hard top bodies are very different so you might struggle |
|
| Author: | islandvitara [ Tue Mar 18, 2008 5:46 pm ] |
| Post subject: | Re: engineer in brisbane |
hmmm... doesnt seem that difficult. but when i do need to get the plate when the vehicle is ready, where do i go? department of transport or to somebody who does mod plates? i dont know were to go. |
|
| Author: | royce [ Tue Mar 18, 2008 5:51 pm ] |
| Post subject: | Re: engineer in brisbane |
dept of transport will give you a list of people near you that can do the plate, then you just have to find 1 first that agrees with what you are doing better to try and get some tips 1st rather than jsut turning up with it and hoping |
|
| Author: | islandvitara [ Tue Mar 18, 2008 7:08 pm ] |
| Post subject: | Re: engineer in brisbane |
haha yep i think i better because i was just going to tidy it all up respray it ect and then take it in... i might just give em a call 1st, cheers, royce
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|