Fatzook wrote:
great success.
sorry couldn't help it.. 
The ARK jerry holders are pretty much the same, they do the job, but maybe hit them with a few extra coats of paint to prevent rust in the corners and where the steel joins together.
| auszookers.com https://auszookers.com/forum/ |
|
| Jerry Can Holders https://auszookers.com/forum/viewtopic.php?f=5&t=18580 |
Page 1 of 1 |
| Author: | rick1970 [ Wed Jan 26, 2011 11:43 pm ] |
| Post subject: | Jerry Can Holders |
Part way through making a swingout wheel carrier and thinking about adding a jerrycan holder on there as well. Had a look at the pre-made holders at ARB and supercheap. Are these any good? Do they hold up to rough roads, as they look a bit om the flimsy side to me. Would i be better of just making one from scratch? Cheers Rick |
|
| Author: | Fatzook [ Thu Jan 27, 2011 12:05 am ] |
| Post subject: | Re: Jerry Can Holders |
Hi Rick. I've used a few of the TJM ones with great success. |
|
| Author: | buzbox [ Thu Jan 27, 2011 12:18 am ] |
| Post subject: | Re: Jerry Can Holders |
Fatzook wrote: great success.
sorry couldn't help it..
The ARK jerry holders are pretty much the same, they do the job, but maybe hit them with a few extra coats of paint to prevent rust in the corners and where the steel joins together. |
|
| Author: | Navy_mike [ Thu Jan 27, 2011 2:11 am ] |
| Post subject: | Re: Jerry Can Holders |
Any photos of the work in progress?? |
|
| Author: | rick1970 [ Thu Jan 27, 2011 2:28 am ] |
| Post subject: | Re: Jerry Can Holders |
Still gotta add a latch, jerry holder and paint. Will be moving number plate and light to rear of jerrycan holder. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|