Yea got some dimples dies that should be here next week
and roctoy ring is going on at the same time
| auszookers.com https://auszookers.com/forum/ |
|
| Transfercase arms https://auszookers.com/forum/viewtopic.php?f=5&t=18587 |
Page 1 of 1 |
| Author: | turbo_deo [ Thu Jan 27, 2011 4:44 am ] |
| Post subject: | Transfercase arms |
I searched but didn't find anything, the transfer arms I got from a wrecker for my rockring, the log arm has big holes where the rubber mounts bolt up to instead of the 3/8? Hole and smaller locating hole, would it be safe to weld a plate in and drill the holes that I need? |
|
| Author: | steak_knife [ Thu Jan 27, 2011 7:47 am ] |
| Post subject: | Re: Transfercase arms |
Yes, while you have the glue gun out brace the rest of it to.. |
|
| Author: | turbo_deo [ Thu Jan 27, 2011 8:33 am ] |
| Post subject: | Re: Transfercase arms |
Yea got some dimples dies that should be here next week and roctoy ring is going on at the same time
|
|
| Author: | Teracis [ Thu Jan 27, 2011 8:51 am ] |
| Post subject: | Re: Transfercase arms |
shit that reminds me to find a place to get a roctoy from! Dimple dies as in for making sheets stronger? (thanks google) is that for your plate you're planning to weld over the holes? |
|
| Author: | turbo_deo [ Thu Jan 27, 2011 8:57 am ] |
| Post subject: | Re: Transfercase arms |
Yea dies to make the sheet stronger, using them because they are super cool and so I can brace my ring to the arms with 3mm plate and still keep it strong, the bigger holes will just be plated glued then re drilled with the right holes |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|