| auszookers.com https://auszookers.com/forum/ |
|
| just wondering 4h without rear tail shaft conected ok??? https://auszookers.com/forum/viewtopic.php?f=5&t=1865 |
Page 1 of 1 |
| Author: | zook89 [ Wed Mar 19, 2008 3:53 pm ] |
| Post subject: | just wondering 4h without rear tail shaft conected ok??? |
just wondering 4h with out rear tail shaft conected ok??? had to drive about 25kms to home with no rear tailshaft only did about 75kmph but there was a bit of vibration isthat because of no rear tailshaft? |
|
| Author: | royce [ Wed Mar 19, 2008 3:55 pm ] |
| Post subject: | Re: just wondering 4h without rear tail shaft conected ok??? |
could of been an out of balance front shaft causing it, you wouldnt have noticed before cause you dont normally do high speeds on flat ground in hi4 I dont think you could or would of damaged anything |
|
| Author: | steve [ Wed Mar 19, 2008 3:57 pm ] |
| Post subject: | Re: just wondering 4h without rear tail shaft conected ok??? |
shayne use to drive to work in front wheel drive because he never got around to getting a replacement rear shaft. I think he did that ages. |
|
| Author: | zook89 [ Wed Mar 19, 2008 5:14 pm ] |
| Post subject: | Re: just wondering 4h without rear tail shaft conected ok??? |
cheers fellas just seemed a bit different to drive but there was some vibration coming from maybe the transfer case |
|
| Author: | zook89 [ Wed Mar 19, 2008 8:29 pm ] |
| Post subject: | Re: just wondering 4h without rear tail shaft conected ok??? |
rear tail shaft all balanced and new uni's not cheap damm it! was done by hardy spicer |
|
| Author: | 11_evl [ Sun Mar 23, 2008 12:01 pm ] |
| Post subject: | Re: just wondering 4h without rear tail shaft conected ok??? |
hardy spicer does good work from what ive heard |
|
| Author: | zook89 [ Sun Mar 23, 2008 7:20 pm ] |
| Post subject: | Re: just wondering 4h without rear tail shaft conected ok??? |
yeah they did a really good job of the shaft now the other two will be getting booked in as the gearbox to transfer case is fyucked. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|