This is how I mated a 1.3 engine to a 1.0 transfer case
| auszookers.com https://auszookers.com/forum/ |
|
| 1 litre transfer into 1.3 https://auszookers.com/forum/viewtopic.php?f=5&t=18690 |
Page 1 of 1 |
| Author: | russty_2008 [ Mon Jan 31, 2011 5:21 am ] |
| Post subject: | 1 litre transfer into 1.3 |
hey just in the middle of putting a 1 litre transfer in my 1.3 finally got the flanges off and they dont interchange i would just redrill holes but that wont work can u join a 1.3 and a 1 litre uni together has anyone done this |
|
| Author: | tanshi [ Mon Jan 31, 2011 5:25 am ] |
| Post subject: | Re: 1 litre transfer into 1.3 |
if they dont interchange then you have the wrong type of 1 litre transfer you can possibly create hybrid shafts |
|
| Author: | christover1 [ Mon Jan 31, 2011 7:05 am ] |
| Post subject: | Re: 1 litre transfer into 1.3 |
use half the 1 litre and half 1.3 yokes ..unis same size, just 1 litre has inner clips, and 1.3 has outer clips |
|
| Author: | christover1 [ Mon Jan 31, 2011 7:08 am ] |
| Post subject: | Re: 1 litre transfer into 1.3 |
This is how I mated a 1.3 engine to a 1.0 transfer case
|
|
| Author: | russty_2008 [ Mon Jan 31, 2011 7:24 am ] |
| Post subject: | Re: 1 litre transfer into 1.3 |
sweet cheers lads |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|