| auszookers.com https://auszookers.com/forum/ |
|
| Removing front Diff centre from Vitara https://auszookers.com/forum/viewtopic.php?f=5&t=18766 |
Page 1 of 1 |
| Author: | shane1992 [ Wed Feb 02, 2011 2:23 am ] |
| Post subject: | Removing front Diff centre from Vitara |
Ok so All the bolts are out, One of the CV's have been undone, Is there anything else that needs to be done? I just flipped it and started throwing shit from sitting in the sun trying to pull it out, It comes apart by a couple of mm's. I just dont want to damage then internals if I pull any harder.... Also do you have to take the axles out of the bacck diff completely? All new to this kind of stuff Cheers |
|
| Author: | christover1 [ Wed Feb 02, 2011 2:29 am ] |
| Post subject: | Re: Removing front Diff centre from Vitara |
have you removed the inner axle, inside the axle housing? It wont pull out without doing that. |
|
| Author: | shane1992 [ Wed Feb 02, 2011 2:35 am ] |
| Post subject: | Re: Removing front Diff centre from Vitara |
Lol that explains it. Thanks |
|
| Author: | christover1 [ Wed Feb 02, 2011 2:47 am ] |
| Post subject: | Re: Removing front Diff centre from Vitara |
rear axles only need sliding out far ebnough to clear diff centre. But best to pull them all the way, check splines and bearings etc while its apart |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|