| auszookers.com https://auszookers.com/forum/ |
|
| Exedy Clutch. https://auszookers.com/forum/viewtopic.php?f=5&t=18895 |
Page 1 of 1 |
| Author: | Munster [ Mon Feb 07, 2011 3:00 am ] |
| Post subject: | Exedy Clutch. |
Exedy list 2 clutches for SJ413 Sierras - SZK6474 and SZK6293. Anybody know which is the ciorrect one to use? Also which are the best T/C mounts to use, I have gone thru 5 in the last 2 months, mainly the Mazda MT8135 ones? This is really annoying as I have hardly put any stress on them especially the last 2, one was even on a downhill run in low range. |
|
| Author: | ZookFisher [ Mon Feb 07, 2011 3:02 am ] |
| Post subject: | Re: Exedy Clutch. |
szk6293... pretty sure |
|
| Author: | tanshi [ Mon Feb 07, 2011 3:03 am ] |
| Post subject: | Re: Exedy Clutch. |
i think it will depend on which gearbox you have. there are two, with different spline counts on the input shafts i believe. most of the time is best to pull the clutch out before buying it |
|
| Author: | xedent [ Mon Feb 07, 2011 4:35 am ] |
| Post subject: | Re: Exedy Clutch. |
yeah count your splines |
|
| Author: | CairnsZook [ Mon Feb 07, 2011 4:39 am ] |
| Post subject: | Re: Exedy Clutch. |
x3 count the splines. Why are you using the Mazda mounts for the t-case? Sounds like they are weaker than the stock mounts. Most people run stock mounts, or stock mounts lifted slightly, or Just-Cruizin's bolt through, lifted mounts. |
|
| Author: | jonno_racing [ Mon Feb 07, 2011 4:44 am ] |
| Post subject: | Re: Exedy Clutch. |
CairnsZook wrote: Just-Cruizin's bolt through, lifted mounts.
x2 im hard on mine and they are still perfect |
|
| Author: | tanshi [ Mon Feb 07, 2011 5:23 am ] |
| Post subject: | Re: Exedy Clutch. |
or make some out of 1 inch door stop rubbers a bolt and some shock rubbers top and bottom |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|