auszookers.com
https://auszookers.com/forum/

checkerplate sill instalation
https://auszookers.com/forum/viewtopic.php?f=5&t=19125		 Page 1 of 1
Author:  maloo11 [ Mon Feb 14, 2011 10:32 pm ]
Post subject:  checkerplate sill instalation
Whats the best way to remove the old sill panel, so you get a nice tidy flat surface to mount the checkerplate?
Author:  Hotshot993 [ Mon Feb 14, 2011 10:41 pm ]
Post subject:  Re: checkerplate sill instalation
You can use a special drill bit used for spot welds. It will make no holes in the panel if used properly or you can do it a bit rougher and use a grinder. If you searched you would find a few threads about this already.
Author:  reeceh [ Mon Feb 14, 2011 11:03 pm ]
Post subject:  Re: checkerplate sill instalation
Drill out spot welds, grind/smooth surface of dags. Remove rust then use a zinc primer. Then predrill plate for rivets glue plate with sikaflex then rivet it on. Then seal all edges .
Author:  Hotshot993 [ Mon Feb 14, 2011 11:15 pm ]
Post subject:  Re: checkerplate sill instalation
i learnt a tip from 2stroker where you dont seal the bottom edge, just incas moisture gets in through the top it can get out through the bottom, but will still stop any mud or anything getting it. good to try it
Author:  reeceh [ Mon Feb 14, 2011 11:24 pm ]
Post subject:  Re: checkerplate sill instalation
Yeh I meant to say not bottom edge, most bottom edges will be to fucked to seal anyway
Author:  zuk85 [ Mon Feb 14, 2011 11:53 pm ]
Post subject:  Re: checkerplate sill instalation
get some rivnuts then u can remove them at anytime for cleaning/ rustproofing lol and just use a foam tape seal around the edges for a bit of security
Author:  Lockie666 [ Tue Feb 15, 2011 12:15 am ]
Post subject:  Re: checkerplate sill instalation
Cable ties?
Author:  maloo11 [ Tue Feb 15, 2011 2:25 am ]
Post subject:  Re: checkerplate sill instalation
Thanks guys. One more job to tick off the list. Only 999 more to go. lol. Front bar next.
Author:  steak_knife [ Tue Feb 15, 2011 7:16 am ]
Post subject:  Re: checkerplate sill instalation
Hotshot993 wrote:
You can use a special drill bit used for spot welds. It will make no holes in the panel if used properly or you can do it a bit rougher and use a grinder. If you searched you would find a few threads about this already.


Bingo, you will still go all the way through from time to time, but it's a shit load less messy then a normal drill of a grinder..
Author:  Hotshot993 [ Tue Feb 15, 2011 7:51 am ]
Post subject:  Re: checkerplate sill instalation
Yeah thank 2stroker for that, he told me that:)
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/