auszookers.com
https://auszookers.com/forum/

G16A to G16B
https://auszookers.com/forum/viewtopic.php?f=5&t=19138		 Page 1 of 1
Author:  Bucket [ Tue Feb 15, 2011 5:11 am ]
Post subject:  G16A to G16B
What needs to be swapped out of a G16A if im going to install a G16B??
Author:  Bucket [ Tue Feb 15, 2011 5:38 am ]
Post subject:  Re: G16A to G16B
Just to make it a little clearer, I've bought another shorty with a busted G16A, and I want to put my G16B into it.

I presume it's a case of pulling the whole wiring loom out of my car and putting it into the new one?? ECU etc aswell
Author:  want33s [ Tue Feb 15, 2011 5:45 am ]
Post subject:  Re: G16A to G16B
Yep entire loom(incl. dash cluster), fuel tank with lines and exhaust.. Pretty much everything else should work....
Author:  Bucket [ Tue Feb 15, 2011 5:45 am ]
Post subject:  Re: G16A to G16B
What's the difference in fuel tanks??
Author:  shakes [ Tue Feb 15, 2011 6:00 am ]
Post subject:  Re: G16A to G16B
Bucket wrote:
What's the difference in fuel tanks??


fuel pump?
Author:  want33s [ Tue Feb 15, 2011 6:08 am ]
Post subject:  Re: G16A to G16B
EFI motor needs an EFI pump which is located in the fuel tank.
Author:  Bucket [ Tue Feb 15, 2011 7:54 am ]
Post subject:  Re: G16A to G16B
Ah ok, there ya go then :) cheers for that.
Should be a good learning experience
Author:  bjmate [ Wed Dec 14, 2011 9:19 am ]
Post subject:  Re: G16A to G16B
Hey mate, how'd you go with the swap. (bit of a late msg haha)
Author:  CairnsZook [ Wed Dec 14, 2011 9:41 am ]
Post subject:  Re: G16A to G16B
Bucket wrote:
What's the difference in fuel tanks??


You'll also need high pressure fuel lines and filter.
Author:  Bucket [ Wed Dec 14, 2011 10:10 am ]
Post subject:  Re: G16A to G16B
Never did it because I ended up flogging both of them off.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/