| auszookers.com https://auszookers.com/forum/ |
|
| Fiberglass H'Top Fitment https://auszookers.com/forum/viewtopic.php?f=5&t=20163 |
Page 1 of 1 |
| Author: | Rusho [ Sun Mar 20, 2011 1:31 am ] |
| Post subject: | Fiberglass H'Top Fitment |
Hi All, For those that have one could you please take a couple of detailed pictures how the rear section sits on. Just want to get an idea of how mine is suppose to go on. Mainly against the b pillar sides and top, and the tub I guess. I just want to get it fitting correctly and modify if need be before we paint it 
Cheers Rusho |
|
| Author: | Zooknoob [ Sun Mar 20, 2011 2:18 am ] |
| Post subject: | Re: Fiberglass H'Top Fitment |
x2 |
|
| Author: | Highway-Star [ Sun Mar 20, 2011 4:18 am ] |
| Post subject: | Re: Fiberglass H'Top Fitment |
This is what I did with mine a few years back.... Don't like bolts, takes to long to remove. Issue with this method is it likes to come loose occasionally when 4wding.... but 4wding with a fibreglass roof on sucks, and the whole point is I take it off in about 30 seconds when I go 4wding. 
|
|
| Author: | Rusho [ Sun Mar 20, 2011 5:15 am ] |
| Post subject: | Re: Fiberglass H'Top Fitment |
Thanks highway star. How does your canopy butt up to the b pillar and targa bar?? |
|
| Author: | tombutt [ Sun Mar 20, 2011 5:38 am ] |
| Post subject: | Re: Fiberglass H'Top Fitment |
you going to get someone to make you a new roll bar to suit the hard top? aslong as it ends up fitting better then a certain silver one it should look good |
|
| Author: | Highway-Star [ Sun Mar 20, 2011 6:02 am ] |
| Post subject: | Re: Fiberglass H'Top Fitment |
Rusho wrote: Thanks highway star. How does your canopy butt up to the b pillar and targa bar??
Mine doesn't butt up, it sits over top of the targa bar. This is one of the places it leaks, the shape of the roof is slightly squarer than the targa bar, so there isn't allot of pressure on seals at each side. An old side on shot, showing it over the targa bar (hence targa bar looks shorter). 
|
|
| Author: | Rusho [ Sun Mar 20, 2011 6:02 am ] |
| Post subject: | Re: Fiberglass H'Top Fitment |
tombutt wrote: you going to get someone to make you a new roll bar to suit the hard top?
aslong as it ends up fitting better then a certain silver one it should look good The old one 'should' fit in 
|
|
| Author: | Rusho [ Sun Mar 20, 2011 6:25 am ] |
| Post subject: | Re: Fiberglass H'Top Fitment |
Cheers HS. Looking at that picture I am 99% sure it's exactly like mine. That's a good pick to go off. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|