auszookers.com
https://auszookers.com/forum/

bar work
https://auszookers.com/forum/viewtopic.php?f=5&t=20759		 Page 1 of 1
Author:  RUN.10W [ Thu Apr 07, 2011 6:08 am ]
Post subject:  bar work
hi
im just curious as to find out if leafy sierra front and rear bars will fit on a coil model sierra?
cheers
Author:  Rusho [ Thu Apr 07, 2011 6:16 am ]
Post subject:  Re: bar work
Should do :wink:
Author:  ellis [ Thu Apr 07, 2011 6:17 am ]
Post subject:  Re: bar work
the front deffs idk about rear but it should
Author:  Reubs [ Thu Apr 07, 2011 6:17 am ]
Post subject:  Re: bar work
RUN.10W wrote:
hi
im just curious as to find out if leafy sierra front and rear bars will fit on a coil model sierra?
cheers

NT and WT bars FRONT bars fit a coily. Example I have run both NT standard and WT ARB bars on my coilies.

Note the coily front clip is angled beneath the headlights. Most leafy bars on coilies look a little out of place because of this.

I can't tell you about the rear as I have a custom bar on one of my coilies and standard on the other.
Author:  RUN.10W [ Thu Apr 07, 2011 6:18 am ]
Post subject:  Re: bar work
sweet thanks mate, so wide track leafy for coily
Author:  RUN.10W [ Thu Apr 07, 2011 6:21 am ]
Post subject:  Re: bar work
yea sweet as thanks heaps guys now to find bar work :)
Author:  Fatzook [ Thu Apr 07, 2011 7:42 am ]
Post subject:  Re: bar work
As Reubs said, the coily front end is slightly different in profile, which makes the leafy bar look a little silly from the side. Otherwise, any leafy bar should fit a coily.

As for the rear bar, the tubs are exactly the same, so the profile of the coly and leafy bars are the same. However there are some mounting differences.
Author:  RUN.10W [ Thu Apr 07, 2011 9:54 am ]
Post subject:  Re: bar work
thanks fatzook will look into it
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/