| auszookers.com https://auszookers.com/forum/ |
|
| Transfer shifter bits install https://auszookers.com/forum/viewtopic.php?f=5&t=20768 |
Page 1 of 1 |
| Author: | SierraDan [ Thu Apr 07, 2011 8:19 am ] |
| Post subject: | Transfer shifter bits install |
How is the install of the shifter done on a Sierra transfer case? I have some balls, springs, poly bush, some clips. |
|
| Author: | steak_knife [ Thu Apr 07, 2011 8:53 am ] |
| Post subject: | Re: Transfer shifter bits install |
was it sloppy??? Just use the bush, most of the other bit's are internal.. Pull transfer stick out, dig out ole bush & fit new in it's place, then stick back in.. |
|
| Author: | SierraDan [ Thu Apr 07, 2011 9:08 am ] |
| Post subject: | Re: Transfer shifter bits install |
It didn't have anything in there that's why I was tripping out. I eventually figured out how everything worked then replaced the bush, spring and cover. Thanks mate |
|
| Author: | steak_knife [ Thu Apr 07, 2011 9:24 am ] |
| Post subject: | Re: Transfer shifter bits install |
|
|
|
| Author: | SierraDan [ Thu Apr 07, 2011 9:31 am ] |
| Post subject: | Re: Transfer shifter bits install |
It's heaps stiff with the poly bush now! |
|
| Author: | Teracis [ Thu Apr 07, 2011 9:34 am ] |
| Post subject: | Re: Transfer shifter bits install |
SierraDan wrote: It's heaps stiff with the poly bush now!
Neither my transfer or my gearbox had a shifter sheet either! I put the twisted tt kit in when I rebuilt my case, the shifter moves heaps further but it's still nice and stiff because of the new sheet! |
|
| Author: | SierraDan [ Thu Apr 07, 2011 9:41 am ] |
| Post subject: | Re: Transfer shifter bits install |
Yeah, it's a definite click into each selection compared to the case in my zook now. Keen to see what it's like in the car. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|