| auszookers.com https://auszookers.com/forum/ |
|
| 4wd not working https://auszookers.com/forum/viewtopic.php?f=5&t=21167 |
Page 1 of 1 |
| Author: | BlackZookie [ Wed Apr 20, 2011 6:37 am ] |
| Post subject: | 4wd not working |
Ok so my hardtop vitara has been sitting around in the backyard for approx 4 months where in that time did not move nor drive it. Put it in 4wd today did the normal lock in the hubs, change to low range and its not engaging into 4wd at all. The 4wd light on dash comes on but definatley hasnt worked still only 2wd. Dont get what has changed/happened. Any ideas? |
|
| Author: | weaves [ Wed Apr 20, 2011 6:42 am ] |
| Post subject: | Re: 4wd not working |
simplest and easiest problem to fix would be your hubs aren't engaging. Its not hard for them to get 'stuck' if it hasn't been used for a while. I would pull the locking hubs off and have a quick check to see if they are operational and work from there. weaves |
|
| Author: | atari4x4 [ Wed Apr 20, 2011 6:42 am ] |
| Post subject: | Re: 4wd not working |
sounds like the FWH might be seized |
|
| Author: | FullyZooked [ Wed Apr 20, 2011 7:15 am ] |
| Post subject: | Re: 4wd not working |
weaves wrote: simplest and easiest problem to fix would be your hubs aren't engaging. Its not hard for them to get 'stuck' if it hasn't been used for a while.
I would pull the locking hubs off and have a quick check to see if they are operational and work from there. weaves +1. I'm guessing there is little to no grease in there. Best give the guts a good clean and pack them with fresh grease. |
|
| Author: | BlackZookie [ Wed Apr 20, 2011 8:44 am ] |
| Post subject: | Re: 4wd not working |
cheers guys thanks for the input will pull them off and check that 1st. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|